OPERATION PB-265LN
26 X7531181900
© 10/23 ECHO Incorporated
Stopping Engine
1. Throttle Position Lever
Move throttle position lever
(A) to START/IDLE ( )
position and allow engine to
return to idle before shutting
off engine.
2. Stop Switch
Move throttle lever (A) to STOP ( ) position.
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your dealer repair stop switch before using unit again.
Operating Blower
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a
poison gas. Breathing CO can cause unconsciousness, serious
injury, or death. Exhaust can cause serious burns. ALWAYS
position unit so that exhaust is directed away from your face
and body.
Always wear safety glasses, hearing protection and a face filter
mask or serious personal injury may result. Do not point the
blower pipe in the direction of people or pets.
Use reduced speed only when performing light-duty tasks or to
comply with local noise regulations. Continuous low speed operation
may allow fuel/oil residue to build-up on the piston and cause rapid
build-up of carbon on the spark arrester screen, resulting in
overheating and engine damage. To reduce harmful build-up, run
engine at wide open throttle for at least 5 minutes every hour, and
inspect/clean the spark arrester screen after approximately 40 hours
of operation.
To Next Page
Loading...
Need help?
General