OPERATION PB-8010 H/T
28 X7501200001
© 11/2018 ECHO Inc.
4. Recoil Starter
Pull recoil starter handle (D) until
engine fires, or a maximum of 5
pulls.
5. If engine fires and remains
running, pull throttle trigger (T
model) or advance throttle lever
(H model) to automatically
return choke to run position,
then proceed to engine warm
up. If engine fires and dies,
proceed to step 6.
6. Choke
After engine fires (or 5 pulls),
move choke lever back to RUN
position, then pull starter
handle/rope until engine starts
and runs. Allow unit to warm up
at idle for several minutes.
Note: If engine does not start
with choke in “RUN”
position after 5 pulls,
move choke to COLD
START position, and
repeat steps 3- 6.
Allow engine to warm up for several minutes before use.
7. Throttle Lever
After engine warm-up, move throttle lever gradually to increase engine
RPM to desired operating speed.
To Next Page
Loading...
Need help?
General
