20
STARTING COLD ENGINE
WARNING DANGER
The cutting attachment should not rotate at idle. If attachment
rotates, readjust carburetor according to "Carburetor Adjustment"
instructions in this manual or see your ECHO Dealer, otherwise
serious personal injury may result.
1. Stop Switch - Start/Run.
Move stop switch button (A) forward away from the STOP
position.
2. Close Choke - Cold Start.
Move choke lever (B) to Cold Start Position.
3. Primer - Pump Bulb.
Pump primer bulb (C) until fuel is visible in the "Clear" fuel return
line. Pump bulb an additional 4 or 5 times.
4. Start - Pull Rope.
Lay the edger on a flat clear area and pull the recoil starter handle
(D) until engine fires.
5. Open Choke - Run.
Move the choke lever to the "RUN" position. Restart engine if
necessary and allow to warm up running at idle for several minutes.
D
B
B
C
PE-230
PE-260
C
PE-260
A
To Next Page
Loading...
Need help?
General