P
OWER
E
DGER
O
PERATOR
'
S
M
ANUAL
21
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING DANGER
When engine starts, the cutting attachment may rotate even with
the throttle trigger in idle (released) position.
1. Stop Switch - Start/Run. Move stop switch button (A) away from
the STOP position.
2. Primer - Pump Bulb. Pump primer bulb (C) until fuel is visible in the
"Clear" fuel return line. Pump bulb an additional 4 or 5 times.
3. Start - Pull Rope. Lay the edger on a flat clear area and pull
the recoil starter handle (D) until the engine fires.
A
C
PE-260
C
PE-230
D
To Next Page
Loading...
Need help?
General