133 INCH CHIPPER/SHREDDER
Section
5 SERVICE & MAINTENANCE
7R SUHYHQW SHUVRQDO LQMXU\RUSURSHUW\ GDPDJH VKXW
RႇHQJLQHDQGPDNHVXUHWKDWDOOPRYLQJSDUWVKDYH
FRPHWRDFRPSOHWHVWRSEHIRUHVHUYLFLQJDGMXVWLQJRU
repairing. Disconnect the battery and remove ignition
key where applicable.
WARNING
The items listed in this service and maintenance schedule
are to be checked, and if necessary, corrective action
taken. This schedule is designed for units operating under
normal conditions. If the unit is operating in adverse or
severe conditions, it may be necessary for the items to be
checked and serviced more frequently.
SEE ENGINE OWNER’S MANUAL FOR FURTHER
ENGINE MAINTENANCE AND TROUBLESHOOTING
INFORMATION.
5.1 MAINTENANCE SCHEDULE
SERVICE AND MAINTENANCE SCHEDULE
FREQUENCY
COMPONENT
MAINTENANCE
REQUIRED
REFER TO ENGINE
OPERATOR’S
MANUAL
BEFORE
EACH
USE
EVERY
8
HOURS
EVERY
25
HOURS
EVERY
50
HOURS
EVERY
YEAR
Engine oil Change (1) Ɣ
Fuel filter Replace Ɣ
Spark plug Check condition and gap Ɣ
Engine oil Check/fill Ɣ
Fuel tank Check/fill Ɣ
All internal and
external nuts and
bolts
Check tightness Ɣ
Chipper blades
Check sharpness and
re-torque to 25 ft-lbs. (2)
Ɣ
Shredder knives Check condition Ɣ
Spark arrestor* Clean Ɣ
Entire machine Clean Ɣ
Drive belt Check Ɣ
Belt tension Check Ɣ
Belt/pulley alignment Check Ɣ
Grease zerks Lube Ɣ
Wheel bearings Check Ɣ
(1) Perform more frequently under extremely dusty conditions.
(2) Perform more frequently when chipping dry or dirty wood.
*If equipped
As the Limited Warranty states, failure by the Owner to perform normal maintenance will void the machine’s warranty. The aggressive,
high-speed nature of chipping REQUIRES THE OWNER TO PERFORM THE ABOVE LISTED NORMAL MAINTENANCE. Special
FRQVLGHUDWLRQWRPDLQWDLQDQGUHWRUTXHWKH&+,33(5$19,/&+,33(5%/$'(6DQG$//,17(51$/$1'(;7(51$/1876$1'
BOLTS is the sole responsibility of the Owner. Failure by the Owner to do so shall be cause for denial of warranty.
ENGLISH
To Next Page
Loading...
Need help?
General
