20 3 INCH CHIPPER/SHREDDER
SERVICE & MAINTENANCE
WARNING
BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,
AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.
5.15 CHANGE OIL
Polyurea and lithium-based greases are not
compatible. Mixing the two grease types may lead to
premature failure.
WARNING
'R QRWRYHU JUHDVH EHDULQJV2YHU¿OOLQJ FDQ OHDGWR
excessive heat and/or unseating of the seals. Add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
NOTE
Lubricate the machine periodically with a lithium-based
grease. Extreme working conditions will require more
frequent greasing.
Grease the following points every 50-100 hours of
operating time:
Ɣ Engine side bearing
Ɣ Chute side bearing
Figure 5.13, Chute Side Bearing Zerk
Figure 5.12, Engine Side Bearing Zerk (Bottom of Bearing)
5.16 LUBRICATION
Check the oil level before each use. Change oil as directed
in the engine owner’s manual.
To Next Page
Loading...
Need help?
General
