33 INCH CHIPPER/SHREDDER
SAFETY
1. Before inspecting, servicing, storing, or changing
DQ DFFHVVRU\ VKXW Rႇ WKHPDFKLQHDQG PDNH VXUH
all moving parts have come to a complete stop.
Disconnect the battery and remove the ignition key
where applicable.
2. Replace any missing or unreadable safety decals.
Refer to the safety decal section for part numbers.
3. Allow machine to cool before storing in an enclosure.
4. Store the machine out of reach of children and where
IXHOYDSRUVZLOOQRWUHDFKDQRSHQÀDPHRUVSDUN
5. Never store this machine with fuel in the fuel tank
inside a building where fumes may be ignited by
DQRSHQÀDPHRUVSDUN,JQLWLRQVRXUFHVFDQEHKRW
water and space heaters, furnaces, clothes dryers,
stoves, electric motors, etc.
6. Drain the fuel and dispose of it in a safe manner for
storage periods of three months or more.
9. (QVXUHGHEULVGRHVQRWEORZLQWRWUDႈFSDUNHGFDUV
or pedestrians.
10. Keep the machine clear of debris and other
accumulations.
11. Do not allow processed material to build up in the
discharge area. This may prevent proper discharge
and can result in kickback of material through the
feed opening.
12. If the machine becomes clogged, the cutting
PHFKDQLVPVWULNHVDQ\IRUHLJQREMHFWRUWKHPDFKLQH
VWDUWVYLEUDWLQJRUPDNLQJDQXQXVXDOQRLVHVKXWRႇ
machine immediately and make sure all moving parts
have come to a complete stop. Disconnect the battery
and remove the ignition key if applicable. After the
machine stops: A) Inspect for damage, B) Replace
or repair any damaged parts, and C) Check for and
tighten any loose parts.
13. On electric start models, disconnect cables from
battery before doing any inspection or service.
Remove key.
14. Check blade bolts for proper torque after every 8 hours
of operation. Check blades and rotate or resharpen
daily or as required to keep blades sharp. Failure
to do so may cause poor performance, damage or
SHUVRQDOLQMXU\DQGZLOOYRLGWKHPDFKLQHZDUUDQW\
1.5 MAINTENANCE/STORAGE SAFETY
ENGLISH
To Next Page
Loading...
Need help?
General
