To Next PageTo Next Page
Need help?Do you have a question about the Echo SRM-250 and is the answer not in the manual?
General| Engine Type | 2-Stroke |
|---|---|
| Shaft Type | Straight |
| Fuel Capacity | 16.9 fl. oz |
| Cutting Swath | 17 in |
| Warranty | 5 year consumer |
Symbol indicating a hazardous situation that will lead to death or serious injury.
Symbol indicating a hazardous situation that can lead to serious injury or death.
Symbol indicating a potentially hazardous situation that may result in minor or moderate injury.
Identifies symbols for safety, operation, and maintenance.
Operator must have proper training and protective equipment.
Operator must wear eye protection against thrown objects and dust.
Wear trim-fitting clothes, safety gloves, sturdy shoes, and long trousers.
Adjust harness and suspension point for proper unit hang.
Fuel is highly flammable; handle with care.
Improper fit can cause cutting attachment to fly off; never start with power transmission shaft removed.
Stop engine immediately if the cutting attachment hits an obstruction.
Keep warm, maintain circulation, limit hours, consult physician for symptoms.
Feed trimmer carefully, tilt head to direct debris away.
Use only the designated blade for the model.
Check blades for cracks and sharpness before each use.
Moving blade hitting brush/trees can cause unit to fly away; dangerous to bystanders.
Included with unit; keep for future reference on safe operation.
Nylon line head or 3-cutter blade for grass, weeds, and debris.
Ignition switch, throttle trigger, lockout, and latch for engine control.
Assemble loop handle and bracket to drive shaft assembly.
Install suspension point and handle correctly, avoiding safety decals.
Always stop engine before replacing line; severe injury can occur if jam is removed while engine runs.
Assemble handle brackets and adjust inclination for comfortable operation.
Check blades for sharpness and cracks; discard cracked blades.
Danger of blade getting loose if worn nut/cup used; replace them with new ones.
Tighten fuel cap after refueling; check for leaks; fire danger if leakage.
Procedure for starting a cold engine using choke and throttle settings.
Cutting attachment rotates when using throttle latch; release latch immediately after engine starts.
If engine doesn't stop, close choke; consult dealer for ignition switch repair.
Close choke, remove cover, brush dirt from filter, reinstall.
Use wire to pick up filter, pull old filter, install new filter.
Cutting attachment must not move at idle after adjustment, or severe injury may result.
Covers issues like fuel, spark, and carburettor problems preventing starting.
Addresses problems like dirty filters, spark plug, carburettor, or cooling system issues.
Store unit in dry, dust-free place, out of reach of children.
Do not store in enclosure where fuel fumes may accumulate or reach flame/spark.
Specifications for nylon line head, blade, and rotational speed.
Engine type, displacement, power, speed, and idle speed.
Fuel type, recommended oil, mixture ratio, and consumption.
