24
Engine operation
Stopping the engine
1. Move the throttle trigger to the idle speed position and set
the engine to idling (i.e. low speed).
2. Move the ignition switch to the Stop position.
3. In the event of an emergency, stop the engine immediately
using the ignition switch.
4. If the engine fails to stop, move the choke lever to the "Cold
Start" position. The engine will stall and come to a halt (an
emergency stop).
∗ If the engine fails to stop when the ignition switch is used, have
the ignition switch checked and repaired by your dealer before
you use the product again.
Always disconnect the spark plug wire from the spark plug to en-
sure the engine cannot be started before you work on the unit or
leave it unattended.
1. Ignition switch 2. Throttle trigger
1. Spark plug wire 2. Spark plug
To Next Page
Loading...
Need help?
General
