EchoStar AD-3600 IP Viaccess - Page 66

Section 7 Troubleshooting
Page 7 - 4 EchoStar AD-3600IP Viaccess
© 2001 EchoStar International Corporation
All rights reserved
6. In a motorized
installation, the positioner
reacts unpredictable
which results in incorrect
positioning of the dish.
■ Thecablesusedare
worn, damaged or
corroded.
■ Inspect the cable for
possible damage and
install new cable as
required.
■ The cable is incorrectly
finished or not sufficiently
shielded.
■ Use sufficiently shielded
and correctly finished
cables.
7. During (initial) setup of
the receiver, no channels
are found.
■ You did not select the
correct LNB(F).
■ On the receiver, in the
installation setup menu
select the correct LNB(F).
■ When installed, you have
selected the incorrect
switch type or port.
■ On the receiver, in the
installation setup menu
make the correct
selections.
■ You have selected the
incorrect satellite to
search channels on.
■ On the receiver, in the
installation setup menu
select the correct
satellite.
■ You have selected the
incorrect search method.
■ At an initial setup, always
choose the option All.
8. The signal indicator
shows one indicator
(only signal strength).
■ You have selected an
analog transponder
■ Select another (digital)
transponder.
Problem Possible cause What to do?