EchoStar AD-3600 IP Viaccess - Delete a Timer

Section 5 Operation
Page 5 - 12 EchoStar AD-3600IP Viaccess
© 2001 EchoStar International Corporation
All rights reserved
3.2. DELETE A TIMER
10. Change the stop time:
a. use the  key, to go to the stop time;
b. read the available help text for information;
c. press the  keys to set the hours;
d. press the OK key to go to the minutes;
e. press the  keys to set the minutes.
11. Change the repetition:
a. use the  key, to go to the period;
b. read the available help text for information;
c. press the  keys to set the repetition.
12. Change the status:
a. use the  key, to go to the status;
b. read the available help text for information;
c. press the  keys to set the status.
13. Save the timer:
a. use the  key, to go to the Store Settings;
b. read the available help text for information;
c. press the OK key to confirm the settings.
14. Note the clock that appeared in your program.
15. Do not forget to program also your VCR.
If the timer screen does not disappear, you have set
a timer in the past or for a running program. Revise
either date, start or stop time to a time in the future
1. On the RCU:
a. press the EPG key;
b. press the GREEN key;
c. select from the list: Timers;
d. press the OK key.
2. Select the applicable timer and press the OK key.
3. Change the status:
a. use the  key, to go to the status;
b. read the available help text for information;
c. press thekey to set the status to inactive.
4. Delete the timer:
a. use the  key, to go to the Store Settings;
b. read the available help text for information;
c. press the OK key to confirm the deletion.