EchoStar D-2510 IP Viaccess - Edit Transponder; Edit Satellite; Select Satellite; Conditional Access

23
Edit Satellite
To delete a transponder, press the red key when the
highlighted bar is located at the transponder you
want to delete.
To add a transponder, press the blue key.
Then, the “Edit/Add SAT or TP” menu will be displaye
d, and you can add a transponder in that menu.
Edit Transponder
Select Satellite
To move to another satellite you want to watch, press the
SAT key( ) on the remote control and choose the proper
satellite with the , keys.
Press the OK key to confirm.
Edit Satellite
ASTRA11
Exit Delete Cancel Add SAT
Satellite Name
i
EL
WL
Select Satellite
HOTBIRD
ASTRA11
2
Exit
i
EL
WL
Edit Transponder
Network(3713H)
Network(3720H)
2
3
4
1
Network(3706H)
ASIASAT2
Network(3727H)
Network(3734H)
Network(3764H)
Network(3766V)
5
6
8
Channel List
CHANNEL ONE
Ch.8 - OS Down
Ch.9 - OS Down
Ch.370. Audio
Ch 371. Audio
Ch.372. Audio
Ch.373. Audio
Ch.374. Audio
Ch.375. Audio
Ch.378. Audio
Network(3661H)
Exit
Delete Cancel Add/ TP
i
7
To delete a satellite, press the red key when the
highlighted bar is located at the transponder you
want to delete.
To add a satellite, press the blue key.
Then, “Edit/Add SAT or TP” menu will be displayed, a
nd you can add a satellite in that menu.
< Common Interface >
From here you will get access to information and
menus from the CI module(Irdeto, Conax,
Cryptowork, Nagravision and Viaccess encryption).
This information may vary depending on the module.
Please see the documentation delivered together with
your CI module.
Conditional Access
Smart Card Information
Conditional Access
2
1
Exit
i
3
Slot 2 : Module not installed
Slot 1 : Module not installed
Viaccess Embedded
Common Interface
< Viaccess Embedded >
Insert the Viaccess smart card into the Smart Card slot on the Front Panel. The chip should be faced upwards.
2 HOTBIRD