EchoStar Viaccess DVR-7000 - Page 18

Section 3 Installation
Page 3 - 8 EchoStar DVR-7000 Viaccess
© 2002 EchoStar International Corporation
All rights reserved
FOR SMATV INSTALLATIONS
30. Make the required selections.
31. Read the available help text for information.
32. Go to the Search Channels field.
33. On the RCU, press the OK key to advance.
34. Wait for the search to complete:
a. the receiver display shows a moving dot;
b. the search completed popup menu appears.
35. On the RCU, press the OK key. to end the initial
setup procedure.
22. Make the required selections.
After the initial installation it is possible to add
more symbol rates. Refer to section Maintenance
for detailed instructions.
23. Read the available help text for information.
24. Go to the Check Signal field.
25. On the RCU, press the OK key to advance.
26. Wait for the search to complete:
a. the receiver display shows a moving dot;
b. the search completed popup menu appears.
27. On the RCU, press the OK key to end the initial
setup procedure.