Ecler CA120 - Page 57

57
GEQ_GAIN
<Zone=ZA:ZD>
<Band=B1:B10>
<Gain=dBx10
>
Sets the current GAIN (dBx10) of one BAND (B1 to B10) of the
GRAPHICAL EQUALIZER for the specified output zone
XOVER_ACTIVE
<Zone=ZA:ZD>
ON/OFF
Sets the current CROSSOVER FILTER status (ON or OFF) for the
specified output zone
XOVER_TYPE
<Zone=ZA:ZD>
LP/HP
Sets the current CROSSOVER FILTER TYPE (LP or HP) for the
specified output zone
XOVER_FREQUENCY
<Zone=ZA:ZD>
<Frequency=Hz>
Sets the current CROSSOVER FILTER FREQUENCY (Hz) for the
specified output zone
COMPRESSOR_ACTIVE
<Zone=ZA:ZD>
ON/OFF
Sets the current COMPRESSOR status (ON or OFF) for the specified
output zone
COMPRESSOR_THRESHO
LD
<Zone=ZA:ZD>
<Threshold=dBx10>
Sets the current COMPRESSOR THRESHOLD LEVEL (dBx10) for the
specified output zone
COMPRESSOR_RATIO
<Zone=ZA:ZD>
<Ratio=x100>
Sets the current COMPRESSOR RATIO (x100) for the specified output
zone
COMPRESSOR_ATTACK
<Zone=ZA:ZD>
<AttackTime=msx10>
Sets the current COMPRESSOR ATTACK TIME (milliseconds x10) for
the specified output zone
COMPRESSOR_RELEASE
<Zone=ZA:ZD>
<ReleaseTime=msx10
>
Sets the current COMPRESSOR RELEASE TIME (milliseconds x10) for
the specified output zone
COMPRESSOR_KNEE
<Zone=ZA:ZD>
SOFT/HARD
Sets the current COMPRESSOR KNEE mode (SOFT or HARD) for the
specified output zone
COMPRESSOR_GAIN
<Zone=ZA:ZD>
<Gain=dBx10>
Sets the current COMPRESSOR GAIN (dBx10) for the specified output
zone
DELAY_ACTIVE
<Zone=ZA:ZD>
ON/OFF
Sets the current DELAY status (ON or OFF) for the specified output
zone
DELAY_TIME
<Zone=ZA:ZD>
<DelayTime=msx10>
Sets the current DELAY TIME (milliseconds x10) for the specified
output zone