Ecler CA120 - Page 58

58
TYPE
PARAM1
PARAM2
PARAM3
PARAM4
DESCRIPCIÓN
DATA
INFO_MODEL
<DeviceModel>
Shows the Device model name
INFO_VERSION
<FirmwareVersi
on>
Shows the current Firmware Version
AUTOLOAD_PRESET1
ON/OFF
Shows the current AUTOLOAD_PRESET1 at Startup function
PRESET_NUMBER
<Preset=P1:P20
>
<Preset=T1:T9>
Shows the current PRESET number (active preset)
PRESET_NAME
<Preset=P1:P20
>
<Preset=T1:T9>
“<Name>”
Shows a certain PRESET (from P1 to P20) or TEMPLATE (from T1 to
T9) name
PRESET_DONE
<Preset=P1:P20
>
<Preset=T1:T9>
Shows that the last SET LOAD_PRESET or SET PRESET_NUMBER
command has been processed: the preset is loaded and active
REMOTE_MODE
<Remote=R1:R4
>
<RemoteMode>
Shows the working mode for a certain REMOTE port (from R1 to R4)
REMOTE_INPUTS
<Remote=R1:R4
>
<Inputs=I1:I6>
Shows the list of inputs affected by the working mode of a certain
REMOTE port (from R1 to R4)
REMOTE_ZONES
<Remote=R1:R4
>
<Zones=ZA:ZD>
Shows the list of outputs affected by the working mode of a certain
REMOTE port (from R1 to R4)
DISPLAY_MODE
<DisplayMode>
Shows the current DISPLAY MODE
LCD_CONTRAST
<Contrast=0:10
0>
Shows the current DISPLAY CONTRAST level
EXT_MUTE_ZONES
<Zones=ZA:ZD>
Shows the list of outputs to be muted by an external contact closure,
connected to the MUTE port
IN_LABEL
<Input=I1:I6>
“<Label>”
Shows the current LABEL (name) for the specified INPUT
IN_STEREO
<Input=I3:I6>
ON/OFF
Shows the current STEREO link status (ON or OFF) for INPUTs 4 and
5
IN_MUTE
<Input=I1:I6>
ON/OFF
Shows the current MUTE status (ON or OFF) for the specified INPUT