USER MANUAL – COLPOSCOPE C100
Page 4 of 32
INMANUUIN161 Rev.2019.04.01 / ENG
1. SYMBOLS
Read the related documentation
Manufacturers information
(Name, Address)
Type of applied BF
equipment
Do not discard with the
household waste
Protective Earth (Ground)
Environmental transport conditions
Manufacturing date (MM/YYYY)
2. SAFETY INFORMATION
2.1 WARNINGS
It is very important to read carefully this manual before using the Ecleris Microstar C-100
Colposcope.
The Ecleris Microstar C-100 Colposcope is an electrical device that provides very high light
intensity. Its use is recommended exclusively for trained personnel.
ECLERIS will not assume any liability for damages that may occur if the device is used without
following the instructions and/or ignoring the following advice:
Keep the device out of children reach.
Do not install the device close to heat sources like stoves.
Do not use the colposcope in places where there is explosion danger.
Always install the device on top of firm and horizontal surfaces, on a perfect ventilated
area.
Do not block the ventilation screens. This ventilation must assure good air flow.
Avoid device exposure to direct sun light, dust, humidity, vibration or shock.
Do not put any container with liquids on top of the device; do not expose the device to
rain or sun.
Do not bend or tied a nut on the power cable, or any cable connected to the device.
Do not use the device during thunderstorms.
After the use of the device, turn it off and disconnect the power cable.
In order to avoid Electrical shocks this system must be connected to a power grid with
proper ground connection. (No exceptions)
This system is not designed to be used in the presence of inflammable anesthetic gases
mixture with air, oxygen, nitrous oxide, or ambient with high oxygen content.
To Next Page
Loading...
