7
Charging
To charge the player, simply connect it to a powered
USB port, or external AC adapter. If you choose to
use a third party adapter, please ensure that it is 5V
and between 350 and 1000mA, or 1amp Low Power
When battery power is low, the player will prompt you,
power off, and enter Standby mode automatically. Do not
try to turn on the unit. You must charge again before
using.
Charger current specification recommended: 400-500mA.
Inserting and removing the Micro SD card
Inserting: Ensure that the player is powered off, and
disconnected from the computer. Hold the Micro SD card
face up (side with words aligned in the opposite direction
of the display screen), and slide the card into the socket
on the player, slightly past flush. When you hear the card
click into place, you can access the card.
Removing: Ensure that the player is powered off, and
push the SD card just past flush. When you hear the click,
release pressure, and the card will slide out.
To Next Page
Loading...
