Figure 17: PC Screen During Software Connection
After the software connection has been completed, operation of the AFRecorder can be
controlled from the PC.
● To leave remote mode:
Remote mode is terminated by selecting "Commands" followed by "Disconnect
AFRecorder" on the PC, or by pressing the "SYS" key twice on the AFRecorder.
Measurement
Measured parameters can be viewed on the PC's screen in two forms: real-time display or
real-time plotting. With both forms, the AFR units are those selected in setup (see Setup -
Display Menu on page 17). The update interval and the measurement averaging are at the
"FAST" rate and are not adjustable (see Table 1 on page 18). During real-time display and
real-time plotting, the AFRecorder also displays the measured parameters.
Real-Time Display
Real-time display duplicates the display format of the AFRecorder on the PC's screen (see
Figure 18).
28
To Next Page
Loading...