Auto-Resetting of the AFRecorder
The AFRecorder contains self-monitoring circuitry ("watchdog") that will reset the
AFRecorder when abnormal operation is detected. After being reset, the AFRecorder will
act as if it was just turned on. Conditions that will cause the AFRecorder to reset itself are:
1. Unreliable or "noisy" power.
2. Excessive spark noise.
Simple experimentation (ex. ground the AFRecorder's case, move the AFRecorder or cabling
away from the engine, or use a separate battery (Model 4800P only)) will usually isolate the
cause and suggest a cure.
44
To Next Page
Loading...