Ecoair DD1 Simple - Page 9

@2022 EcoAir - V1.5 Page 6 All rights reserved (E&OE)
SETUP CONTINUOUS DRAINAGE
STEP 1
Knockout
STEP 2
Hose
STEP 3
Hose
Use a hose with an inner diameter of 12mm for connuous drainage:
1. Use a screwdriver to remove the knockout at the back.
2. Ensure the water tank is well ed in posion. Then, push the hose (B1) through the knockout
and make sure it aaches rmly to the open tap securely.
3. Once the hose is securely aached to the open tap, lead the other end of the hose to an
appropriate drain at a downward slope with no sharp bends.
NOTE:
• When using the dehumidier with a connuous hose aached, never pull out the
tank. This may cause water leakage or damage to the open tap. If you need to re-
move the water tank, ensure that the hose is disconnected rst.
• Never leave the end of connuous drainage hose outside when the temperature is
below 1°C to avoid leakage. (When the outdoor temperature is at freezing point the
water will not ow freely and this will cause a blockage consequently pushing the any
condensaon back to the dehumidier and leakage will occur).