Ecoer EAHAEC-60 - Page 85

85/157
SDi Decades Extreme Service Manual www.ecoer.com
May. 2023Manufacturer reserves the right to change specifications or designs without notice.
21
press "On/Off" for 2s to enter the Cooling Temperature Compensation
Value Settings, the code displayed is “Ch”, then press "OK" to send the
Query Cooling Temperature Compensation Value code; press the
Up/Down key to select the cooling temperature compensation value,
then press "OK"; and press "On/Off" for 2s to exit.
22
press "On/Off" for 2s to enter the Heating Temperature Compensation
Value Settings, the code displayed is “Ch”, press "OK" to send the
Query Heating Temperature Compensation Value code; press the
Up/Down key to select the heating temperature compensation value,
then press "OK"; and press "On/ Off" for 2s to exit.
23
Reserved
/
24
25
26
27
28
29
30
• In Channel 1~30 settings of the engineer mode, long press the On/off key to return the previous engineer
mode. Exit of engineer mode:
1)In engineer mode, press the key combination of “On/Off + Air speed” for 2s;
2)The engineer mode will be exited if there are no valid key operations for continuous 60s.