ECOFOREST Eco I Insert - Page 64

63
• Dirty stove.
•
Too intensive use.
A005
Minimum NTC temperature.
• Badly planned installation in terms of space.
• Boiler working at low power levels.
• Disconnected NTC.
A006 Maximum NTC temperature.
• Air in the circuit.
• Little dissipation of the energy generated.
• Too heavily used.
• Shortcut in NTC.
A007 Minimum water pressure.
• Filling the heating circuit.
• Disconnected Pressure switch.
• Broken Pressure switch.
A008 Maximum water pressure.
• Lowering operating pressure between 1.2 and 1.5
bar.
• Installing a bigger expansion vessel.
•
Air in the circuit.
A009 Minimum room temperature.
• Low temperature in the room.
• Disabling the room sensor.
• Lowering operating temperature.
A010 Maximum room temperature.
• Too much temperature in the room.
• Disabling the room sensor.
•
Increasing operating temperature.
A011
Minimum CPU Temperature.
• CPU Temperature below the minimum.
A012 Maximum CPU Temperature.
• Dirty stove.
• Dirty or broken convector.
• Inadequate installation of the gas output pipe.
A013
Motor currents below the minimum.
• Reviewing motor connections.
A014
Motor currents above the maximum.
• Reviewing motor short circuits.
A015 Depression air level too low.
• Minimum depression operating conditions.
• Dirty stove.
• Dirty exhaust pipe.
• Housing door or ash box incorrectly closed.
•
Cleaning outlet left open.
A016 Maximum gas temperature alert
• It has reached the gas output safety.
•
Temperature and the pellet will drop.
A017 Maximum NTC temperature alert.
• It reduces fuel drop due to excess temperature in
convection chamber or water flow.
A018
El extractor se pone al 100% y no alcanza la
depresión mínima de trabajo de forma
continuada.
• Stove/heater dirty.
• Need to perform maintenance work.
A019 Extractor de la salida de gases al 100%
• Stove/heater dirty.
•
Need to perform maintenance work.
A020
Probes error
• Possible sensor change.
A021
Minimum temperature in probe for outside
temperature. (OPTIONAL, check availability).
• Temperature below -25°C.
A022
Maximum temperature in probe for outside
temperature. (OPTIONAL, check availability).
• Temperature above 55°C.
A023
Minimum temperature in probe for return
temperature.
• Installation of boiler badly measured.
• Boiler working to low levels of power.
• Disconnected NTC.
• NTC badly placed.
A024
Maximum temperature in probe for return
temperature
• Air in the circuit.
• Little dissipation of the energy generated.
• Too heavily used.
• Shortcut in NTC.