Ecolab MIKRO-MASTER 300 User Manual

6.0 START-UP PROCEDURES
5
Figure 7
ANTI-SIPHON
VALVE
DIVIDER
NUMBERS
MIXING
CHAMBER
PRODUCT
TUBING
DRAIN
TUBING
PROGRAMMABLE
DIVIDER
FLOW METER
INLET VALVE
(OPTIONAL)
The dosage ratio is an amount of chemical solution to be
added or injected into an amount of water using the same unit
of measure. Dosage ratios are determined by setting the
divider number of the programmable divider.
1. To set the divider number, remove the clear window on the
divider. Set thumb wheel switches to divider number
determined on the chart located at the right. Divider num-
bers are precalculated for each sanitizer/lube listed and
could vary slightly up or down depending on external
conditions.
2. Turn on the water supply to the unit and open the input
valve (optional). When water flows through the flow meter,
the pump will start pumping, allowing solution to the spray
outlets.
IMPORTANT - THE PUMP SHOULD NOT BE ALLOWED
TO STROKE MORE THAN 80 STROKES PER MINUTE
AS DAMAGE TO THE PUMP WILL RESULT.
3. Check the dosage ratio. If the concentration is too high, set
the programmable divider number up slightly. If the con-
centration is too low, set the divider number down slightly.
DOSAGE DIVIDER NO.
PRODUCT RATIO SETTING
Mikro-Klene DF 1.00 oz. per 10 gal. 40
Bevro-Klene 1.00 oz. per 10 gal. 40
Bac-Flush 1.00 oz. per 52 gal. 117
K-San 1.00 oz. per 2 gal. 8
Mandate 1.00 oz. per 6 gal. 24
Ster-Bac 1.00 oz. per 4 gal. 16
P3 Oxonia Active 1.00 oz. per 3 gal. 10
Fas-Trac (1%) 1.28 oz. per 1 gal. 3
Fas-Trac (.5%) .64 oz. per 1 gal. 6
Klenz-Glide 1 (1%) 1.28 oz. per 1 gal. 3
Klenz-Glide 1 (.5%) .64 oz. per 1 gal. 6
Klenz-Glide 5 (1%) 1.28 oz. per 1 gal. 3
Klenz-Glide 5 (.5%) .64 oz. per 1 gal. 6
Klenz-Glide 10 (1%) 1.28 oz. per 1 gal. 3
Klenz-Glide 10 (.5%) .64 oz. per 1 gal. 6
Klenz-Glide 20 (1%) 1.28 oz. per 1 gal. 3
Klenz-Glide 20 (.5%) .64 oz. per 1 gal. 6
Klenz-Glide 30 (1%) 1.28 oz. per 1 gal. 3
Klenz-Glide 30 (.5%) .64 oz. per 1 gal. 6
Klenz-Glide PL (1%) 1.28 oz. per 1 gal. 3
Klenz-Glide PL (.5%) .64 oz. per 1 gal. 6
Lubri-Klenz (1%) 1.28 oz. per 1 gal. 3
Lubri-Klenz (.5%) .64 oz. per 1 gal. 6
Lubri-Klenz LF (1%) 1.28 oz. per 1 gal. 3
Lubri-Klenz LF (.5%) .64 oz. per 1 gal. 6
Replace clear window to activate programmable
divider.
IMPORTANT - THE DIVIDER WILL NOT OPERATE
UNLESS WINDOW IS IN PLACE.

Ecolab MIKRO-MASTER 300 Specifications

General

Brand	Ecolab
Model	MIKRO-MASTER 300
Category	Water Pump
Language	English