EcoNet RETST800SYS - Away and Vacation Mode Settings

EcoNet
®
Smart Thermostat User Guide 15> Return to Table of Contents
Settings (con’t)
Smart Control – Smart Control is used to reduce or prevent water
condensation on the inside of windows while humidifying in the winter season.
The control monitors indoor and outdoor temperatures and reduces the
humidification percentage according to the Smart Control level chosen by the
user. Start out with the Low setting. If objectionable condensation occurs on
windows, choose the Medium or High setting.
Humidify With Fan – If there is a call to humidify and the fan and heating/
cooling are off, the fan will be forced on to humidify. Select the desired fan
speed from Low to High.
Note: Humidification is only available if a humidifier is installed.
How to test a humidifier
Adjust the humidify set point up to ‘TEST’, select Humidify during “Heat/Fan”, then turn on a continuous fan
speed on the Fan screen under Settings. This should force the humidifier to run. This setting will last for 30
minutes, where the maximum setting will return to 4% below the dehumidification set point.
Away Settings (Menu > Settings > Away)
Your system will follow the customized heating, cooling and fan settings when
you place your system into ‘Away’ mode. The system can be placed into
Away by selecting the Home icon (closed door) on the home screen. Once
the system is placed into Away mode it will remain until canceled. Simply tap
the Away icon (open door) to exit Away mode. The system will resume the
schedule or return to the previous settings if a schedule is not being followed.
You can also exit Away by increasing or decreasing the temperature.
Note: If your system is in Cool or Heat when placed into Away mode your system will only manage to
the respective Away set point.
Vacation (Menu > Settings > Vacation)
The Vacation screen allows you to preschedule desired heating, cooling and
fan settings when you are going to be away for an extended time.
To schedule your vacation, select the time, month, day and year and then use
the up and down arrows to set desired start and end dates.
Note: You will need to set the vacation end time and date before you can set its start.
Select each set point and fan speed and then use the up down arrows to set
to your desired vacation conditions. We recommend setting the fan speed
to Auto.
36
UNITS
34
Group 1
Refrigeration
!
75
44%
80
65
Away
Resume Schedule
71
Home 44%
70
80
Cooling to
Enable Humidification?
Humidify Set Point
Humidify During...
Smart Control
Humidity With Fan
BACK
Humidification
30 %
Heat
Off
Off
No
36
UNITS
34
Group 1
Refrigeration
!
75
44%
80
65
Away
Resume Schedule
71
Home 44%
70
80
Cooling to
BACK
Settings
Installer
Away
Humidity
Time
Basic
Vacation
Fan
36
UNITS
34
Group 1
Refrigeration
!
75
44%
80
65
Away
Resume Schedule
71
Home 44%
70
80
Cooling to
BACK
Vacation Settings
85º
Auto65º
Start:
End:
Vacation
02:00 pm Jan. 29 2018
02:30 pm Feb.
10
2018
Yes
Water
Heater
Yes
36
UNITS
34
Group 1
Refrigeration
!
75
44%
80
65
Away
Resume Schedule
71
Home 44%
70
80
Cooling to
BACK
Settings
Installer
Away
Humidity
Time
Basic
Vacation
Fan