Ecosoft FU1013CABDVUP User Manual

16 17
MANUAL FOR ECOSOFT COMPACT WATER SOFTENERS
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibit
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2023 ecosoft.com
9. TROUBLESHOOTING
PROBLEM CAUSE CORRECTION
6. Brine will not draw
during regeneration
or not all brine will
draw.
Low supply water pressure. Check supply water pressure.
Clogged injector or brine tube. Clean brine injector and/or brine tube.
Clogged basket or salt crystals on ball in
air check valve.
Clean air check valve basket and/or ball.
High pressure drop on the lter (control
valve, distributors or lter media are
clogged).
See paragraphs 1 and 4.
Air is injected due to brine line not being
airtight.
Check airtightness of the drain line.
Control valve settings changed. Increase brine stage duration.
7. Brine tank is not
relled or relled
with less water than
needed.
Low supply water pressure. Check supply water pressure.
Clogged injector or brine tube. Clean brine injector and/or brine tube.
Stuck ball in the air check valve. Clean the air check valve.
Control valve settings changed. Check the duration of brine tank rell and
correct if necessary.
8. Excess use of salt
per renegeration.
Control valve settings changed. Decrease the amount of salt per
regeneration in the control valve settings.
Brine tank lled with excess water. See paragraph 9.
9. Brine tank is
relled with excess
water.
High main water pressure. Check water pressure. Install pressure
regulator if needed.
Control valve settings changed. Check the duration of brine tank rell and
correct if necessary.

Ecosoft FU1013CABDVUP Specifications

General

Brand	Ecosoft
Model	FU1013CABDVUP
Category	Water Dispenser
Language	English