14
MANUAL FOR ECOSOFT PINK SOFTENERS
This manual is the intellectual property of Ecoso. Copying and reprinng is prohibited. © 2024
8. SERVICE
8.1 MAINTENANCE WORK
To ensure proper operaon soener, the user should regularly carry out the following checks:
Check the presence of salt and if necessary, add.
Check water hardness: hardness of drinking water and the hardness of mixed water should be
checked no less than 2 mes a year, if necessary, it should be adjusted the hardness of the mixed
water (see the “Installaon” secon).
Check for ghtness, carry out: visual inspecon: check for possible leakage of all connecons and
pipelines. Check the cleanliness of the salt and saline soluon storage capacity 1 me in 2 months,
if necessary, clean and rinse clean water.
The indicated terms of the recommended inspecons are available are minimal and must be
adjusted, depending on operang condions.
8.2 USER RESPONSIBILITY
Any technical equipment requires regular maintenance.
Constantly monitor the quality and level of soened pressure water If the water quality has
changed, change it too parameter sengs are set. If necessary, consult a specialist.
Regular checks by the operator are required as a guarantee normal funconing of the device.
Emollient water should be regularly inspected compliance with the condions of its operaon.
Frequency of checks performed by the user:
Aer use: add salt for regeneraon.
2 mes a year: check the pressure.
2 mes a year: check water quality.
Once a year: clean the salt tank.
8.3 SERVICE AND SPARE PARTS
Parts that wear out must also be replaced in the specied maintenance period so that to guarantee
awless operaon of the installaon and perform warranty condions. Soener maintenance it is
recommended to carry out once a year.
Replacement of wearing parts can be performed only qualied personnel (specialists of the
organizaon water supply or service).
We recommend concluding a service contract service with our service department.
Cleaning: do not use alcohol for cleaning or alcohol-based detergents to avoid damage surfaces
of plasc parts.
8.4 DISPOSAL
Aer the end of the service life of the installaon contact Ecoso Service to arrange soener
replacement. Disposal of soener and of all electrical parts is carried out only in specialized
recycling centers.