7 EN
Quick Start
1. It is recommended to add the tap water into the Water Tank. The
maximum volume of the Water Tank is about 60 ml, and it can spray
for about 60 minutes when the Water Tank is full.
2. Wet and wring out the Wiping Pad and place it flat on the velcro at
the bottom of WINBOT. Pay attention to align the narrow and wide
side accordingly.
3. Connect WINBOT Compound Cable, Power Adapter and Plug.
Please ensure the battery is fully charged before using. Charging time
will be approx. 4 hours.
* Do not power off WINBOT while it is running, as it may pose a risk of
falling.
4. Tie the Safety Rope
Properly tie the Safety Rope to a stable object that cannot be easily
moved (e.g. table leg, chair leg, bed leg, sofa leg, curtain rod, stair
handrail, etc.), and lock the carabiner as shown below.
Note: When WINBOT is working, make sure there is someone nearby
to supervise.
Maximum
：
60ml
To Next Page