Need help?Do you have a question about the EcoWater ECR 3002R30 and is the answer not in the manual?
General| Brand | EcoWater |
|---|---|
| Model | ECR 3002R30 |
| Category | Water Filtration Systems |
| Language | English |
Covers pre-installation reading, gathering tools, and handling the unit with care.
Addresses avoiding freezing, hot water, direct sunlight, and outlines flow/pressure needs.
Details FCC compliance, water treatment limitations, and equipment disposal requirements.
Details warranty coverage, how it works, obtaining service, and replacement parts.
Outlines conditions, disclaimers, and limitations of the warranty coverage.
Confirms Safeco Insurance Company guarantees EcoWater Systems LLC's performance.
Explains water hardness, its effects, and the types of iron found in water.
Describes sediments, barium, and radium, including EPA MCLs and testing.
Shows cabinet and two-tank model installation diagrams and bypass valve options.
Details requirements for drain discharge and a grounded electrical outlet.
Instructions for installing bypass valves or copper tubes to the softener.
Covers turning off water supply and installing a 3-valve bypass system.
Details connecting inlet/outlet plumbing and grounding the cold water pipe.
Guides on connecting and routing the valve drain hose to a floor drain.
Instructions for installing overflow hose and adding water and salt to the brine tank.
Covers sanitizing the unit, connecting the transformer, and starting a recharge.
Guides for first-time setup, including model code, time, and water hardness settings.
Setting the automatic recharge time and configuring the remote monitor.
Completing sanitization via recharge and restarting the water heater.
Describes normal screen displays and how program memory functions.
Explains keypad functions, beeper sounds, and the salt level setting.
Covers initiating extra recharges and navigating the primary menu.
Details how to set clock, water hardness, and recharge time within the primary menu.
Describes screens for water flow rate, water used today, and average water use.
Covers settings for rolling display, clock format, units (gallons/liters, grains/PPM).
Details remote status, sending EASE messages, and setting the interface language.
Covers testing remote, setting low salt alert, and configuring efficiency mode.
Instructions on how to change the controller's model code for optimal operation.
Procedure to reset all controller settings to factory defaults.
Describes the remote monitor's LEDs, signal status, and battery checks.
Steps to change the remote monitor's channel to avoid signal interference.
Covers refilling salt, recommended types, breaking salt bridges, and resin bed cleaning.
Instructions for cleaning the nozzle and venturi assembly for proper brine suction.
Details procedures for depressurizing, pressurizing, and operating bypass valves.
Outlines initial operational checks and introduces electronic diagnostics.
Explains the unit's self-diagnostic function and lists common error codes.
Guides for performing manual diagnostics and interpreting results.
Procedure to verify regeneration cycles, brine draw, and flow rates.
Provides dimensional drawings and nominal resin tank sizes for various models.
Lists the salt storage capacities for two-tank and cabinet brine tanks.
Details softening capacity, salt dose efficiency, and flow rates by model.
Provides detailed performance data like hardness limits and operating pressures by model.
Lists part numbers and descriptions for the main conditioner assembly.
Continues listing part numbers and descriptions for conditioner assembly components.
Lists part numbers and descriptions for various valve assembly components.
Lists part numbers and descriptions for valve components, including nozzle/venturi.
To Next Page