37
Using BIOS
Integrated Peripherals
These options display items that define the operation of peripheral components on the
system’s input/output ports.
fOnChip IDE Device
Scroll to this item and press <Enter> to view the following screen:
Phoenix-AwardBIOS CMOS Setup Utility
OnChip IDE Device
Item Help
Menu Level
ff
IDE HDD Block Mode [Enabled]
ATA 66/100 Cable Msg [Enabled]
IDE DMA transfer access [Enabled]
On-chip Primary PCI IDE [Enabled]
IDE Primary Master PIO [Auto]
IDE Primary Slave PIO [Auto]
IDE Primary Master UDMA [Auto]
IDE Primary Slave UDMA [Auto]
On-chip Secondary PCI IDE [Enabled]
IDE Secondary Master PIO [Auto]
IDE Secondary Slave PIO [Auto]
IDE Secondary Master UDMA [Auto]
IDE Secondary Slave UDMA [Auto]
*** On-Chip Serial ATA Setting***
On-chip Serial ATA [Disabled]
PATA IDE Mode [Primary]
SATA Port P1,P3 is Secondary
IDE HDD Block Mode (Enabled)
Block mode is also called block transfer, multiple commands, or multiple sector read/write.
If your IDE hard drive supports block mode (most new drives do), select Enabled for
automatic detection of the optimal number of block read/write per sector the drive can
support.
OnChip IDE Device [Press Enter]
Onboard Device [Press Enter]
SuperIO Device [Press Enter]
f
f
f
f
Phoenix-AwardBIOS CMOS Setup Utility
Integrated Peripherals
Item Help
Menu Level
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
mnlk
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
mnlk
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
ATA 66/100 Cable Msg (Enabled)
This item enalbes or disabled the display of the ATA 66/100 Cable Msg. If you install a
device that supports UDMA, change the appropriate item on this list to Auto. You may
have to install the UDMA driver supplied with this motherboard in order to use an UDMA
device.
To Next Page
Loading...
Need help?
General
