Chapter 3
B250H4-M20 USER MANUAL
54
This page enables you to set setup administrator password and user password.
Security Menu
Administrator Password Status (Not Install)
This item shows administrator password installed or not.
Secure Boot (Enabled)
This item is used to control the secure boot flow, it is possible only if system runs in
User Mode.
Main Advanced Chipset Tweak Security Boot Exit
+/- : Change Opt.
Enter/Dbl Click : Select
: Select Screen
/Click: Select Item
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
Set Administrator Password
System Mode state (Setup)
This item shows system mode setup or not.
Secure Boot state (Not Active)
This item allows you to enable or disable the secure boot state.
Administrator Password
Administrator Password Status Not Install
User Password Status Not Install
System Mode state Setup
Secure Boot state Not Active
Secure Boot Enabled
Secure Boot Mode Standard
Secure Boot Mode (Standard)
This item is used to select the secure boot mode.
User Password Status (Not Install)
This item shows user password installed or not.
To Next Page
Loading...
Need help?
General
