ECS G41T-R3 User Manual

26
Using BIOS
Press the delete key to access the BIOS Setup Utility.
Resetting the Default CMOS Values
When powering on for the first time, the POST screen may show a
“CMOS Settings Wrong” message. This standard message will appear
following a clear CMOS data at factory by the manufacturer. You
simply need to Load Default Settings to reset the default CMOS
values.
Note: Changes to system hardware such as different CPU, memories,
etc. may also trigger this message.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
f
f
f
f
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
f
: Move
F10: Save ESC: Exit
+/-/: Value
Enter : Select
F9: Load Default Settings
F1:General Help
f
f
f
Standard CMOS Setup
Advanced Setup
Advanced Chipset Setup
Integrated Peripherals
Power Management Setup
PCI/PnP Setup
PC Health Status
Frequency/Voltage Control
Load Default Settings
Supervisor Password
User Password
Save & Exit Setup
Exit Without Saving
f
f
mnlk
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
f
f
f
f
v02.59(C)Copyright 1985-2005, American Megatrends, Inc.
f
: Move
F10: Save ESC: Exit
+/-/: Value
Enter : Select
F9: Load Default Settings
F1:General Help
f
f
f
Standard CMOS Setup
Advanced Setup
Advanced Chipset Setup
Integrated Peripherals
Power Management Setup
PCI/PnP Setup
PC Health Status
Frequency/Voltage Control
Load Default Settings
Supervisor Password
User Password
Save & Exit Setup
Exit Without Saving
f
f
mnlk
Load Default Settings?
[OK] [Cancel]

ECS G41T-R3 Specifications

General

Brand	ECS
Model	G41T-R3
Category	Motherboard
Language	English