Chapter 3
H61H2-M17 USER MANUAL
53
When end-users encounter failure after attempting over-clocking, please take the
following steps to recover from it.
1. Shut down the computer.
2. Press and hold the “Page Up Key (PgUp)” of the keyboard, and then boot the PC
up.
3. Two seconds after the PC boots up, release the “Page Up Key (PgUp)”.
4. The BIOS returns to the default setting by itself.
Warning:
Over-clocking components can adversely affect the reliability of the system
and introduce errors into your system. Over-clocking can permanently
damage the motherboard by generating excess heat in components that are
run beyond the rated limits.
Fail-Safe Procedures for Over-clocking
B.O.M.P Technology (Enabled)
This item allows users to enable or disable B.O.M.P technology. This function can run
safe setting to setup menu when system boot fail 3 times.
Auto Detect DIMM/PCI C1k (Enabled)
When this item is enabled, BIOS will disable the clock signal of free DIMM/PCI slots.
Spread Spectrum (Enabled)
If you enable spread spetrum, it can significantly reduce the EMI (Electro-Magnetic
Interference) generated by the system.
Intel(R) Pentium(R) CPU G640 @ 2.80GHz
This is display-only field and displays the information of the CPU installed in your
computer.
Processor Speed (2800 MHz)
This item shows the CPU speed.
Memory Frequency (1066 MHz)
This item shows the memory frequency.
Total Memory (1024 MB (DDR3))
This item shows the total memory.
To Next Page
Loading...
Need help?
General
