JBAT1: Clear CMOS Jumper
This jumper is to clear the contents of CMOS memory. You may need to clear
the CMOS memory if the settings in the Setup Utility are incorrect that pre-
vents your mainboard from operating. To clear the CMOS memory, disconnect
all the power cables from the mainboard and then move the jumper cap into
the CLEAR setting for a few seconds.
Function Jumper Setting
Normal Short Pins 1-2
Clear CMOS Short Pins 2-3
JP1A1, JP1B1: CPU Clock
This jumper enables to select CPU frequency.
CPU Clock JP1A1 JP1B1
100M Short Pins 1-2 Short Pins 2-3
133M Short Pins 2-3 Short Pins 1-2
JP2: Keyboard Power On
This jumper enables any keyboard activity to power up a system previously in
a standby or sleep state.
Function Jumper Setting
5V Short Pins 1-2
5VSB Short Pins 2-3
J1: USB Card Reader Voltage Selector (VCC)
This jumper enables to select voltage of the USB Card Reader.
Function Jumper Setting
5V Short Pins 1-2
5VSB Short Pins 2-3
12
To Next Page
Loading...
