CPU / System Temperature
These items display CPU and system temperature measurement.
FANs & Voltage Measurements
These items indicate cooling fan speeds in RPM and the various system volt-
age measurements.
Change Password
If you highlight this item and press Enter, a dialog box appears that you can
enter a Supervisor password. You can enter no more than six letters or num-
bers. Press Enter after you have typed in the password. There will be the
second dialog box asking you to retype the password for confirmation. Press
Enter after you have retyped it correctly. Then, the password is required for
the access to the Setup Utility or for it at start-up, depending on the setting of
the Password Check item in Advanced Setup.
Exit
Highlight this item and press Enter to save the changes that you have made in
the Setup Utility configuration and exit the program. When the Save and Exit
dialog box appears, press Y to save and exit, or press N to exit without saving.
This concludes Chapter 3. Refer to the next chapter for information on the
software supplied with the mainboard.
C
C
h
h
a
a
p
p
t
t
e
e
r
r
4
4
31
To Next Page
Loading...
Need help?
General
