30
Using BIOS
Advanced BIOS Features
This option defines advanced information about your system.
!
X
X
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
"#$%
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
ATA66/100 IDE Cable Msg. [Enabled]
Hard Disk Boot Priority [Press Enter]
Quick Power On Self Test [Enabled]
First Boot Device [Floppy]
Second Boot Device [Hard Disk]
Third Boot Device [CDROM]
Boot Other Device [Enabled]
Boot Up Floppy Seek [Disabled]
Boot Up NumLock Status [On]
Typematic Rate Setting [Disabled]
Typematic Rate (Chars/Sec) 6
Typematic Delay (Msec) 250
Security Option [Setup]
APIC Mode [Enabled]
OS Select For DRAM > 64MB [Non-OS2]
HDD S.M.A.R.T. Capability [Disabled]
Video BIOS Shadow [Enabled]
Small Logo (EPA) Show [Disabled]
Phoenix-AwardBIOS CMOS Setup Utility
Advanced BIOS Features
Item Help
Menu Level
!
ATA 66/100 IDE Cable Msg (Enabled)
Enables or disables the ATA 66/100 IDE Cable Msg. This message will appear during reboot
when you use 40-pin cable on your 66/100 hard disks.
Hard Disk Boot Priority (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Phoenix-AwardBIOS CMOS Setup Utility
Hard Disk Boot Priority
Bootable Add-in Card
Item Help
Menu Level
!!
Use < > or < > to
select a device, then press
<+> to move it up, or <->
to move it down the list.
Press <ESC> to exit this
menu.
"
#
: Move PU/PD/+/-/: Change Priority F10:Save ESC:Exit
"#
!
Quick Power On Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
To Next Page
Loading...
Need help?
General
