EasyManuals Logo

ECS PM800-M2 User Manual

ECS PM800-M2
67 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
40
Using BIOS
Soft-Off by PWRBTN (Instant-Off)
Under ACPI (Advanced Configuration and Power management Interface) you can create a
software power down. In a software power down, the system can be resumed by Wake Up
Alarms. This item lets you install a software power down that is controlled by the power
button on your system. If the item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec. then you have to hold the power
button down for four seconds to cause a software power down.
Ac Loss Auto Start (Off)
This item defines how the system will act after AC power loss during system operation.
When you set to Off, it will keep the system in Off state until the power button is pressed.
IRQ/Event Activity Detect (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
!
VGA [Off]
LPT & COM [LPT/COM]
HDD & FDD [ON]
PCI Master [OFF]
PowerOn by PCI Card [Enabled]
Modem Ring Resume [Disabled]
RTC Alarm Resume [Disabled]
Date (of Month) 0
Resume Time (hh:mm:ss) 0 : 22 : 0
IRQs Activity Monitoring [Press Enter]
Phoenix-AwardBIOS CMOS Setup Utility
IRQ/Event Activity Detect
Item Help
Menu Level
!
!
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
"#$%
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
!
X
X
VGA (OFF)
When set to On, the system power will resume the system from a power saving mode if
there is any VGA activity.
LPT & COM (LPT/COM)
When this item is enabled, the system will restart the power-saving timeout counters when
any activity is detected on the serial ports, or the parallel port.
HDD & FDD (ON)
When this item is enabled, the system will restart the power-saving timeout counters when
any activity is detected on the hard disk drive or the floppy diskette drive.
PCI Master (OFF)
When set to Off, any PCI device set as the Master will not power on the system.
PowerOn by PCI Card (Enabled)
Use this item to enable PCI activity to wakeup the system from a power saving mode.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ECS PM800-M2 and is the answer not in the manual?

ECS PM800-M2 Specifications

General IconGeneral
BrandECS
ModelPM800-M2
CategoryMotherboard
LanguageEnglish

Related product manuals