Eden XLT - Plugging In; Connecting Cabinets

HI FIDELITY FOR LOW FREQUENCY | 11
EDEN | D-SERIES | PLUGGING IN - 8
Plugging In
Eden D series cabinets are tted with a crossover control. This enables you to dial in more or less tweeter / horn in
your mix to help compensate for different playing environments and audio requirements.
Avoid running any cabinet with a crossover control at 0 for long periods of time as this can decrease the life of the
controller. To plug your amplier into your cabinet rst ensure that your cabinet is the correct impedance and has
the right power handling rating capabilities. Connecting to your cabinet couldn't be easier, simply plug into any of
the provided sockets and your done, your Eden cabinet is tted with 2 Speakon connectors and 2 ºî Jack socket
connectors this allows you to take the signal input to the cabinet to another cabinet in as a link.
Eden always recommends that where possible connections should be made using Speakon cables and
connections as this provides the best possible solution for your connectivity needs.
NEVER ATTEMPT TO PLUG 2 AMPLIFERS INTO A SINGLE CABINET.
1. Speakon Connection; Connect your cabinet to an amplier here.
2. Speakon Connection; Connect this cabinet to another cabinet here.
3. Crossover Control; Adjust the amount of tweeter level here.
4. ¼" Jack Socket; Connect your cabinet to an amplier here.
5. ¼" Jack Socket; Connect your cabinet to another cabinet here.