Eden XLT - About Impedance; Impedance Calculation; Multi-Cabinet Impedance

HI FIDELITY FOR LOW FREQUENCY | 9
About Impedance
To calculate the impedance of the rig you have chosen we have provided a simple to use impedance calculator
in the table below. Just remember that with some ampliers a change of impedance will increase or decrease the
power output of the amplier you are using. With Tube ampliers using the incorrect impedance can seriously
damage your amplier. Make sure if you are plugging an amplier into 2 cabinets that both of them can handle the
power you are running though them. If the cabinets you are using are not of equal impedances the output to the
cabinet will not be shared equally which will affect the power handling requirements depending on your setup. Also
remember to follow the advice on impedances specied by your ampliers manufacturer.
Please note impedances shown are approximate for rig setup purposes.
Ω1 x 4O 4OΩ1 x 6 O 6OΩ1 x 8O 8OΩ2 x 4O 2OΩ2 x 8O 4OΩ1 x 4O + 1 x 8O 2.6OΩ1x 4 O + 1 x 6O 2.4OΩ1 x 8O + 1x 6O 3.4O
IMPORTANT: Some bass ampliers have two output ampliers, when plugging in your cabinets you should
ensure that the load and handling matches the requirement for the amplier you are plugging into.
EDEN | D-SERIES | ABOUT IMPEDANCE - 6