Edge-Core ECS2100-28P - User Manual

– 1 –
Quick Start Guide
10/28-Port Web-Smart Pro Gigabit Ethernet Switch
ECS2100-10T/ECS2100-10P/ECS2100-10PE
ECS2100-28T/ECS2100-28P/ECS2100-28PP
The ECS2100 series switches include the following models:
ECS2100-10T— 8 10/100/1000BASE-T + 2 SFP uplink ports
ECS2100-10PE— 8 10/100/000BASE-T + 2 SFP uplink ports (4 PoE ports)
ECS2100-10P— 8 10/100/1000BASE-T + 2 SFP uplink ports (8 PoE ports)
ECS2100-28T— 24 10/100/000BASE-T + 4 SFP uplink ports
ECS2100-28P— 24 10/100/000BASE-T + 4 SFP uplink ports (24 PoE ports)
ECS2100-28PP— 24 10/100/000BASE-T + 4 SFP uplink ports (24 PoE ports)
N OTE : The ECS2100 series switches are for indoor use only.
N OTE : For Safety and Regulatory information, refer to the Safety and Regulatory
Information document included with the switch.
ECS2100-10PE
ECS2100-10P
ECS2100-10T
ECS2100-28P
ECS2100-28PP
ECS2100-28T
E012016-AP-R01
150200001318A
www.edge-core.com

Edge-Core ECS2100-28P Specifications

General

Model	ECS2100-28P
Type	Managed Switch
PoE Budget	370W
Switching Capacity	56 Gbps
Forwarding Rate	41.66 Mpps
MAC Address Table	16K
Jumbo Frame Support	9KB
Layer	Layer 2
VLANs	4096
Power Supply	AC 100-240V
Dimensions (W x D x H)	440 x 44 x mm
Operating Temperature	0 to 50 °C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24x 10/100/1000BASE-T PoE+ ports, 4x 1G SFP uplinks

Summary

Install the Switch

Rack Mounting

Details the process of mounting the switch into a standard 19-inch rack.

Installation Safety Caution

Ground the Switch

Grounding Procedure

Describes how to connect a grounding wire to the switch and rack for safety.

Grounding Safety Warning

Connect Power

AC Power Connection

Details connecting the switch to an AC power source for operation.

AC Power Requirements

AC-DC Power Adapter Connection

Power Connection Safety Caution

Make Initial Configuration Changes

Web Interface Configuration

Explains initial configuration via the web-based management interface using RJ-45.

Console Port Configuration

Details initial configuration using the command-line interface (CLI) via the console port.

Connect Network Cables

SFP Transceiver and Cable Installation