Edge-Core ECS2100-28PP - User Manual

– 1 –
Quick Start Guide
10/28-Port Web-Smart Pro Gigabit Ethernet Switch
ECS2100-10T/ECS2100-10P/ECS2100-10PE
ECS2100-28T/ECS2100-28P/ECS2100-28PP
The ECS2100 series switches include the following models:
ECS2100-10T— 8 10/100/1000BASE-T + 2 SFP uplink ports
ECS2100-10PE— 8 10/100/000BASE-T + 2 SFP uplink ports (4 PoE ports)
ECS2100-10P— 8 10/100/1000BASE-T + 2 SFP uplink ports (8 PoE ports)
ECS2100-28T— 24 10/100/000BASE-T + 4 SFP uplink ports
ECS2100-28P— 24 10/100/000BASE-T + 4 SFP uplink ports (24 PoE ports)
ECS2100-28PP— 24 10/100/000BASE-T + 4 SFP uplink ports (24 PoE ports)
N OTE : The ECS2100 series switches are for indoor use only.
N OTE : For Safety and Regulatory information, refer to the Safety and Regulatory
Information document included with the switch.
ECS2100-10PE
ECS2100-10P
ECS2100-10T
ECS2100-28P
ECS2100-28PP
ECS2100-28T
E012016-AP-R01
150200001318A
www.edge-core.com

Edge-Core ECS2100-28PP Specifications

General

Model	ECS2100-28PP
Type	Managed Switch
PoE	Yes
PoE Budget	370W
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
MAC Address Table	16K
Operating Temperature	0°C to 50°C
Storage Temperature	-40°C to 70°C
Power Consumption	Max 400W
Jumbo Frame Support	9K
Management	CLI, Web, SNMP
Power Supply	AC 100-240V, 50/60Hz
Dimensions (W x D x H)	440 x 44 x 250 mm
Humidity	10% to 90% (non-condensing)

Summary

Unpack the Switch

Install the Switch

Rack Mounting

Mount the switch in a standard 19-inch rack using provided brackets and screws.

Wall Mounting

Mount the ECS2100-10PE model on a wall with RJ-45 ports facing up for safe operation.

Ground the Switch

Connect Power

Verify Switch Operation

Make Initial Configuration Changes

Via RJ-45 Port

Configure switch settings using the web interface by connecting a PC to an RJ-45 port.

Via Console Port

Access the command-line interface (CLI) through the serial console port for initial setup.

Connect Network Cables

Extend PoE Budget