3-6
Installing the Switch
3
Connecting to a Power Source
First verify that the external AC power supply can provide 100 to 240 VAC,
50-60 Hz, 3 A minimum.
Note: For international use, you may need to change the AC line cord. You must use a
line cord set that has been approved for the receptacle type in your country.
To connect a device to a power source:
1. Insert the power cable plug directly into the socket located at the back of the
device.
Figure 3-6 Power Receptacle
2. Plug the other end of the cable into a grounded, 3-pin socket.
3. Check the front-panel LEDs as the device is powered on to be sure the System
LED is on. If not, check that the power cable is correctly plugged in.
To Next Page
Loading...
Need help?
General
