Plug the Chiller into a standard 120v
grounded power supply with 15 amp
minimum circuit and test the GFCI
functionality. To perform the test, first
ensure the Power Switch on the back of
the Chiller is up in the “on” position and
then press the orange “T” Test Button
above the Power Switch. The Power Switch
should flip to the down “off” position.
Now flip the Power Switch back up to the
“on” position. (see image). If this test does
not cause the Power Switch to turn off,
do not proceed, and contact support for
assistance. Place the Power Plug in an
elevated position off the ground and
away from water. Do not handle with wet
hands. You may now turn on the Chiller
by pressing the “Power On” button on the
display screen. The Chiller may take up to
2-3 minutes to purge air from the system
and will flash “o1.x” or “02.x” while
purging.
Once this has been completed, this code
will change to the current water
temperature and water will flow from the
“Water In” fitting on the Tub and the
Chiller will begin cooling or heating. If the
“FL” (Flow) error appears, or if this step
takes longer than 2-3 minutes, check that
the Valves are open, and that the hose
connections and filter housing are
connected properly, and then repeat this
step.
To change the temperature set point,
press and hold the “S” key for 2-3
seconds until the Set Point flashes, and
then use the up or down arrow keys to
set your desired temperature. Press
the “S” key once more to confirm the
setting. Your Tub will reach minimum
or maximum temperature in about 3
hours depending on ambient
temperature and set point. Child lock
can be enabled by pressing and
holding both the “Up” and “Down”
arrow keys simultaneously until a beep
is heard and a lock appears on the
screen.
Add 60cc (2 Measuring Cup) of
Oxidizer into water
Wait 15 minutes
Add 15cc (½ Measuring Cup) of
Sanitizer into water
Wait 15 minutes before entry into
Tub
Prior to use, the water should be
treated with the startup Sanitizer dose.
The startup dose is below and should
be used any time the water is replaced
in the Tub.
1.
2.
3.
4.
Please refer to the Water Maintenance
Instructions for the weekly protocol for
maintaining clean water in your Tub.
Step 8 – Power on the
Chiller
05 Setup Instructions
Step 10 – Startup water
sanitation
(see image).
Step 9 – Set your
temperature
Step 11 – Cover your Tub
Finally, put the Cover on if the Tub will
not be immediately used, and secure
the four Locking Buckles. Note that the
factory combination code for the
Locking Buckles is 0-0. See “Setting
Buckle Code” write-up in section 9 for
instructions on how to change the
combination code.
Enjoy your new Edge Tub!
Please watch the Water Maintenance Instructional video
for the weekly protocol you need to follow to ensure the
water stays clean and clear. Enjoy!
14
To Next Page
Loading...