Inner Water Strainer - The cylindrical mesh element
that attaches to the Chiller Inlet (red).
Strainer O-Ring - The o-ring at the base of the External
Water Strainer connection (red) on the Chiller.
Water Strainer Cover - The metal cover that will screw
on the Chiller Inlet (red) over the Inner Water Strainer.
External Water Strainer - The assembly of parts that is
used to prevent any debris from entering the Chiller. It
connects to the Chiller Inlet (red) and is made up of the
Water Strainer Cover, Strainer O-Ring, and Inner Water
Strainer.
Inflation Valve - The port used to inflate the Edge Tub
with the Double Action Air Pump. Includes the Inflation
Valve Cap, and Inflation Valve Pin.
6
Inflation Valve Cap - The cap that covers and protects
the inflation valve on the tub.
Inflation Valve Pin - The spring loaded component of
the Inflation Valve that is exposed when the Inflation Valve
Cap is removed.
Power Plug - The plug that connects to a power
source.
Power Switch - The power switch that toggles the
Chiller power on/off.
Storage Strap - The strap for securing the tub
when deflated.
Tub - The inflatable tub.
Tub Cover - The lockable cover for your tub.
Locking Buckles - The locking buckles on the tub cover
that fasten and lock the cover to the tub when not in use.
Tub Fitting - The male connection permanently
installed on the Tub Water In (green) and Water
Out (red) fittings.
Tub Valve Fitting - The connection elbow/valve
that connects the Tub Fittings to the Chiller Hoses
running from the chiller. The parts of the Tub
Valve Fitting are the Threaded Collar, Elbow, and
Valve.
Elbow - The 90 degree section of pipe connecting the
Connection Ring and the Valve.
Threaded Collar - The female rotating threaded
component on the Tub Valve Fitting that connects to the
Tub Fitting.
Valve - The stainless steel valve that controls water flow.
To Next Page
Loading...