3
Parts Included
Protective Grille
(baffle)
Foam Seal
(Adhesive Backed)
Window Lock
Bracket and Screw
Preparations for Installing the Window Kit
You must vent your portable air conditioner when running it in Cool
or Dry (dehumidify) mode. Your unit includes a window exhaust kit
that can be used to vent moisture out a window.
Before you begin, make sure you have all the parts necessary for
installation.
If you have multiple windows, choose one that is near an electrical
outlet that will be able to provide sufficient power to your unit. See
the power requirements listed on the product label printed on the
side, or on the back of your portable air conditioner.
Please follow the installation instructions carefully to avoid personal
injury or damage.
NOTE: You may need to contact
your electrician if your room’s circuit
is not able to power your unit.
When positioning unit, please allow
for proper distance from wall as
shown below.
Suggested Tools- Phillips
Screw Driver (Medium
sized), Tape Measure/Ruler,
Scissors, Saw (In the event
that your window panel
needs to be cut down in size
for installation)
To Next Page
Loading...
Need help?
General
