EdgeStar Portable Air Conditioner 16
Modes and Features
AUTO: When selecting Auto Mode, the air conditioner will operate
automatically according to the ambient room temperature. The set
temperature is not adjustable in AUTO mode. This is the default
mode of operation when the unit is powered on.
COOL: If the ambient temperature drops below the temperature
you selected, the compressor turns off and the unit functions with
the fan only. When the temperature rises above the temperature
you selected, the compressor turns on again. The Cool Indicator
will be lit. You can press the “+” or “-“ to increase or decrease the
set temperature.
NOTE: Whether your desired temperature can actually be reached
depends on the ambient conditions. The room temperature remaining
slightly above the set temperature is normal.
To operate the unit in cooling mode:
1) Make sure the power cord is plugged into a power outlet.
2) Press the ON/OFF button on the remote.
3) Press the Mode button until the Cool Indicator Light on the
Control Panel lights up.
4) Select the fan speed by using the Fan button.
5) Set the thermostat by using the “+” and “-“ buttons on the
remote. The thermostat is adjustable between 61°F - 86°F in one
degree increments.
DRY: When dry mode (or dehumidify mode) is selected, the air
conditioner operates under dry mode at a low fan speed. The Dry
Indicator light will be lit. Under dry mode the fan speed can’t be
adjusted.
FAN: Fan Only mode is used to circulate the air in your room. No
temperature setting is needed.
To operate the unit in Fan Only mode:
1) Make sure the power cord is plugged into a power outlet.
2) Press the ON/OFF button on the remote.
3) Press the Mode button until the Fan Indicator light on the control
panel lights up.
4) Press the Fan button to adjust fan speed.
HEAT: If the ambient temperature reaches the temperature you
selected, the heat pump turns off and the unit functions with the fan
only. When the temperature drops below the temperature you
selected, the heat pump turns on again. The Heat Indicator will be
lit. You can press the “+” or “-“ to increase or decrease the set
temperature.
NOTE: The exhaust hose must
be used in cooling mode in order
to cool a room.
NOTE: Fan Only mode does not
require that the exhaust hose be
attached.
NOTE: This unit unitizes a heat
pump to provide the heating
function. The heat pump will not
work properly if ambient
temperature is below 50F.
To Next Page
Loading...
Need help?
General
