17
Modes (Continued)
TIMER: Pressing the Timer will activate the Timer Mode settings.
Pressing "+" or "-" buttons the adjust the timer setting in increments
of ½ hour up to 10 hours and then in increments of 1 hour up to 24
hours while using the remote control. The display will remain in
timer mode for five (5) seconds and then revert back to displaying
temperature. Press the Timer button again to cancel the timer
mode.
SLEEP: Pressing the Sleep button on the remote will turn Sleep
mode on or off. The Sleep Mode can be activated when in Cool
Mode or Heat Mode and will not operate when in Fan Mode. When
operating in Cool Mode, the Sleep function will slowly raise the
Temp Control by 4° degrees Fahrenheit over the initial 2 hour Sleep
Mode period. When operating in Heat Mode, the Sleep function will
slowly lower the Temp Control by 4° degrees Fahrenheit over the
initial 2 hour Sleep Mode period. When the Sleep Mode is active,
the LCD will continue to display the Sleep Mode status.
X-Fan: The X-Fan mode will operate the indoor fan at low speed to
remove any residual moisture through the exhaust hose. The X-
Fan mode is available in COOL or DRY modes only. After the unit
has been turned off, the X-Fan function may continue to operate for
up to 10 minutes in order to dissipate any moisture collected in the
unit.
TURBO: The Turbo function sets the unit into an accelerated mode
that enables the unit to reach the desired temperature setting in a
shorter amount of time. Pressing the Turbo button will activate /
deactivate the Turbo function.
To Next Page
Loading...
Need help?
General
