EdgeStar AP14001HS - Advanced Operations

11
Dehumidify Mode
In dehumidify mode, air is dehumidified as it passes through the unit, while some cooling
continues to occur. If the room temperature is higher than 77°F, the fan speed can be
adjusted. Otherwise the fan speed will be maintained at “Low.”
Fan Mode
Air is circulated throughout the room as cooling continues to occur.
Heating Mode
Heating is activated only when the ambient temperature is below 77°F. In this mode, the
desired temperature can be set between 61°F and 77°F.
Fan Speed Control
The Fan Speed Control has 3 settings: High, Medium, and Low.
Timer
Auto Turn Off
While the unit is running, press the timer button to select the number of hours you would like
the unit to continue to run in air conditioning mode until it automatically shuts off.
Auto Turn On
While the machine is in standby mode, press the timer button to select the number of hours you
would like the unit to remain in standby mode until it automatically starts running in air
conditioning mode.
Timer / Temp Set Control Wheel
This wheel is used for adjusting the timer settings and the set temperature. The default display on
the screen next to this wheel is the current room temperature.
Note: The warm air exchange hoses must vent inside the room when using Dehumidify Mode,
not outside as they do when cooling. If the unit is vented outside some cooling will occur.
Note: The unit does not need to be vented while it is running in fan mode.
Note: When the appliance is in heating mode, both air hoses must be connected to the unit and
used to vent air to the outside.