EdgeStar AP14003W - Remote Control Features and Error Codes

Your portable air conditioner comes with a remote control that has
identical functions as on your control panel with two additions:
SET TEMPERATURE
AUTO[ I I | FAN
COOL | JH_GH
DRYl ! _ED
HEAT LOW
T TE_Pi
&4OO£ ON€OFF FAN$_EE#
• -[i
C:b : :i
0 0
LOCK button (remote control only): Press this recessed button to lock
all current settings, the controller will not accept any new operations
until the LOCK button is pressed again to release. A lock symbol will
display on the LED display to indicate this function is active.
RESET button (remote control only): Press this recessed button to
cancel all current settings, the unit will return to initial settings.
ERROR CODES on LED display:
El- Room temperature sensor error.
E2- Evaporator temperature sensor error.
E3- Display panel communication error.
For all error codes, unplug the unit and plug it back in, if error repeats
call for service.
PROTECTION CODES on LED display:
P1- Room temperature sensor error. Connect the drain hose and drain
the collected water away. If error repeats call for service.
EdgeStar Portable Air Conditioner 12