Maintenance
Clean the air conditioner and filters regularly to maximize performance
and efficiency, and prolong the unit's life. Be sure to always unplug the
air conditioner from the power outlet before cleaning.
Cleaning the unit
Use a soft dry cloth to wipe the body clean. If necessary, use lukewarm
water to dampen a cloth to clean the unit.
Use a soft bristle brush to clean between the vents.
Carefully use a vacuum cleaner to clean the condenser coils.
Never use abrasive chemicals, volatile substances, gasoline,
detergents, chemically treated cloths, or other cleaning solvents that
may damage the cabinet exterior.
Never spray water directly on the unit.
Cleaning the pre-[ilter
To clean the pre-filter, follow the steps below:
Warning: Never operate the
unit without the pre-filter.
1) Power off the unit and remove the pre-filter.
2) Use a vacuum cleaner or tap the filter lightly to remove loose dust
and dirt, then rinse thoroughly under lukewarm running water (below
lo4°@. You may use a mild soap and water solution if needed. Allow
the pre-filter to air dry in a cool and shaded place. Dry thoroughly
before reinstalling.
Clean the pre-filter periodically. If the unit is used in a dusty
environment you may need to clean it on a weekly basis.
Preparation/or Storage
If you are not going to be using the unit for an extended period of
time, follow the instructions below before storing your unit:
1) Drain all the water from the unit's reservoir. Operate the unit in fan
mode for a few hours to thoroughly dry any moisture left on the coils
inside the unit.
2) Power off the unit, and clean or change the filters.
3) Unplug and carefully wind the power cord.
4) Remove the exhaust hose and adapters and keep them in a safe
place.
EdgeStar Portable Air Conditioner 14
To Next Page
Loading...
Need help?
General
