Remote Centre
The remote control sensor receives infrared signals given by the
remote control.
When the unit is on, press the timer button to initiate the Auto-off stop
program, the TIMER OFF indicator light will illuminate. Press the UP or
DOWN button to select the desired time. Press the TIMER button
again within five seconds, the Auto-on start program is initiated and
the TIMER ON indicator light will illuminate. Press the UP or DOWN
button to select the desired Auto-on start time.
When the unit is off, press the TIMER button to initiate the Auto-on
start program, press it again within five seconds and the Auto-off stop
program will initiate.
Press or hold the UP or DOWN button to change the Auto time by o.5
hour increments, up to lo hours, then at 1 hour increments up to 24
hours. The control will count down the time remaining until the unit
starts. The system will automatically revert back to display the
previous temperature setting if there is no operation in a five second
period.
Select to initiate the SLEEP operation. On the remote this function is
labeled as "ECONOMY". Press this button; the set temperature will
increase by 1o C/2 o F in 3o minutes. The set temperature will then
increase by another 1 o C/2 o F after an additional 3o minutes. This new
temperature will be maintained for 7 hours before it returns to the
originally selected temperature. This ends the SLEEP mode and the
unit will continue to operate as originally programmed. This feature is
only available in COOLING and AUTO mode.
Increase/Decrease
Used to adjust (increasing/decreasing) temperature settings (1 o C / 2 o F
increments) in a range of 17 ° C (62 o F) to 3o ° C (88 ° F) orthe TIMER
setting in a range of 1-24 hrs.
The control panel is capable of displaying temperature in Fahrenheit or
Celsius. To convert from one to the other, press and hold the UP and
DOWN buttons at the same time for 3 seconds.
Fan [ndicato
Press to select the fan speed in two speeds- LOW, MED, HIGH and
AUTO. The fan speed indicator light illuminates under different fan
settings.
11
To Next Page
Loading...
Need help?
General
